I bought a used, but very good condition TS3 driver this weekend and I’m pretty happy with it. I have it setup currently with a Fujikura Speeder Pro TS stiff flex shaft in the A1 configuration, and the weight currently set for neutral standard weighting.

The thing is though, is that the previous owner had set up the CG weighting for draw I think, and both the weights were stacked at one end of the capsule rather than one at each end. When I tried initially to install the adjustable weight on the other end though, it would not readily go on, and needed light persuasion into place, on the form of inserting the capsule into the driver head, then the loose weight, and using the screw cap to push it into place. It seems to be alright, just wondering why it was such a tight fit to begin with.

Anybody else have this happen? Is the repeated shock of striking the ball causing a small amount of deformation in the polymer end of the weight perhaps? Thanks!